WELCOME TO Hongkong NKF Machinery Co.,Limited. English | Spanish

v groove bearings

v groove bearings
Author :Admin | Publish Date:2012-12-17 09:03:55
The summary of my point was that you supported a strong axial [v groove bearings] , with a weak axial bearing (radial bearing), but if you supported it with another strong axial bearing (thrust bearing) it would be an improvement.


1.) The v-groove bearings ARE rated for axial loads (as well as the obvious radial loads), yet they are deflecting when applying force on the axial axis "lever". They should be able to handle that, but they aren't.
2.) Your solution is to compress/sandwich the v groove bearings, between one/two other "things". This provides both a wider stance on the axial bolt, and some preload forces.
3.) However, you chose to use regular radial bearings. Unlike the v-groove bearings, or thrust bearings, regular radial bearings are almost never rated for axial loads - they are only meant to take radial loads. Some radial bearings will actually even have slop axially.
4.) Using thrust bearings (I said "washers" incorrectly, before), or another item designed to take axial loads, will likely give improved results. They will be intended to handle loads in this direction, so they will experience less deflection, and will live longer.
5.) You still may need to shim them. All that your shimming is doing is mechanically connecting the two bearings, because otherwise there is a gap.


There's no doubt that you'll get a more consistent behavior from a more consistent contact profile. But I don't get the impression that that's the problem here. If it were the problem, then the solution would be to increase the tension between the top and bottom fag bearings, which was the one prong of the original post. (There's also plenty of anecdotal evidence on this forum that over time the steel V-groove bearings will eventually conform the comparatively soft aluminum rails to such a profile anyway.) The other prong was removing axial slop from the v-groove bearings. In an ideal world, the v-groove bearings would just not have any significant axial slop. I think combining what was initially proposed with what Awesomeness shared, we'd want something like this


The trick seems to be finding the right flanged sleeve bearings. I didn't find anything on McMaster available in the sizes we'd need for this particular job in 5-10 mins of searching. While the quasi-floating shims illustrated in the original proposal can do the job of coupling the outer races of the bearings, I would prefer a more stable, less float-y solution, like the one illustrated in my quick-n-dirty illustration here.


Quote: "the v-groove bearings ARE rated for axial loads". I did not know this. I just ordered the bearings yesteday. All ball bearing assemblies (V-groove, not withstanding) will accept a certain amount of axial loading, but their primary function is to handle radial loads. Even if a timken bearing can handle an axial load, there will still be a certain amount of deflection between the inner and outer races. It is true however that a bearing has to have a preload in order to eliminate the slop between inner and outer races. I guess the solution may be how to preload the bearings. The preloading could be compared to backlash between a threaded rod and the nut.


AEL- 205 (25mm)
AEL- 207 (35mm)
MJH 18161 (NEEDLE BEARING)

Contact Us

TEL:00852-54978621
FAX:00852-54979628
Email:sales@dbearings.com
Add:UNIT 04,7/F BRIGHT WAY TOWER,NO 33 MONG KOK ROAD,KL
WhatsApp:8618112377009

timken information lists

Copyright © 2014 Hongkong NKF Machinery Co.,Limited. All rights reserved. TEL:00852-54978621 FAX:00852-54979628 Email:sales@dbearings.com